|
RMX SPECIFICATIONS |
RMX 2450 |
STEREO MODE, EIA: Both Channels Driven
|
Continuous Average Output Power Per Channel |
|
8 ohms EIA 1 kHz, 0.1% THD |
500W |
|
4 ohms EIA 1 kHz, 0.1% THD
|
750W |
|
2 ohms EIA 1 kHz, 1% THD |
1200W |
|
BRIDGE MONO MODE
|
Bridge Mono Mode Operation |
|
8 ohms EIA 1 kHz, 0.1% THD |
1500W |
|
4 ohms EIA 1 kHz, 1% THD |
2400W |
|
Signal to Noise, 20 Hz-20 kHz |
100 dB |
|
Distortion (SMPTE-IM) |
Less than 0.01% |
|
Input Sensitivity @ 8 ohms |
1.23v (+4.0 dBu) |
|
Voltage Gain |
50x (34 dB) |
|
Output Circuitry |
Class H |
|
Power Requirements
1/8 power pink noise at 4 ohms * |
10 A |
| Weight |
44.5 lb (20.2 kg) net |
|
ALL MODELS |
|
Distortion (Typical) |
|
|
?20 Hz-20 kHz: 10 dB below rated power |
Less than 0.03% THD 4 and 8 ohms |
|
?1.0 kHz and below: full rated power |
Less than 0.03% THD 4 and 8 ohms |
|
Frequency Response |
20 Hz-20 kHz, +/- 1 dB, -3 dB points: 5 Hz-50 kHz |
|
Damping Factor, 1 kHz and below |
Greater than 300 at 8 ohms |
|
Input Impedance |
10 k ohms unbalanced, 20 k ohms balanced |
|
Input Clipping |
10 Vrms (+22 dB) |
|
Cooling |
Continuously variable-speed fan, rear-to-front air flow |
| Connectors, each channel |
Input: Active balanced; barrier strip, XLR and 1/4" (6.3mm)
TRS tip and XLR pin 2 positive
Output: touch-proof binding posts and Neutrik Speakon |
| Controls |
Front: AC switch, Ch. 1 and Ch. 2 gain knobs
Rear: 10-position DIP switch |
| Indicators |
Power On: Green LED; Signal: Yellow LED, 1 per channel
Clip: Red LED, 1 per channel |
| Amplifier Protection |
Full short circuit, open circuit, thermal, ultrasonic, and RF protection
Stable into reactive or mismatched loads |
Load Protection
|
On/off muting, AC coupling (850, 1450), triac crowbar
(2450, on each channel) |
| Dimensions |
19" (48.3 cm) rack mounting, 3.5" (8.9 cm) tall (2 rack spaces),
15.9" (40 cm) deep (rack mounting to rear support ears) |
| Power Requirements |
100, 120, 230 VAC, 50-60 Hz |
