RMX SPECIFICATIONS |
RMX 1450 |
STEREO MODE, EIA: Both Channels Driven
|
Continuous Average Output Power Per Channel |
8 ohms EIA 1 kHz, 0.1% THD |
280W |
4 ohms EIA 1 kHz, 0.1% THD
|
450W |
2 ohms EIA 1 kHz, 1% THD |
700W |
BRIDGE MONO MODE
|
Bridge Mono Mode Operation |
8 ohms EIA 1 kHz, 0.1% THD |
900W |
4 ohms EIA 1 kHz, 1% THD |
1400W |
Signal to Noise, 20 Hz-20 kHz |
100 dB |
Distortion (SMPTE-IM) |
Less than 0.01% |
Input Sensitivity @ 8 ohms |
1.15v (+3.4 dBu) |
Voltage Gain |
40x (32 dB) |
Output Circuitry |
AB |
Power Requirements 1/8 power pink noise at 4 ohms * |
7A |
Weight |
40 lb (18.2 kg) net |
ALL MODELS |
Distortion (Typical) |
|
?20 Hz-20 kHz: 10 dB below rated power |
Less than 0.03% THD 4 and 8 ohms |
?1.0 kHz and below: full rated power |
Less than 0.03% THD 4 and 8 ohms |
Frequency Response |
20 Hz-20 kHz, +/- 1 dB, -3 dB points: 5 Hz-50 kHz |
Damping Factor, 1 kHz and below |
Greater than 300 at 8 ohms |
Input Impedance |
10 k ohms unbalanced, 20 k ohms balanced |
Input Clipping |
10 Vrms (+22 dB) |
Cooling |
Continuously variable-speed fan, rear-to-front air flow |
Connectors, each channel |
Input: Active balanced; barrier strip, XLR and 1/4" (6.3mm) TRS tip and XLR pin 2 positive Output: touch-proof binding posts and Neutrik Speakon |
Controls |
Front: AC switch, Ch. 1 and Ch. 2 gain knobs Rear: 10-position DIP switch |
Indicators |
Power On: Green LED; Signal: Yellow LED, 1 per channel Clip: Red LED, 1 per channel |
Amplifier Protection |
Full short circuit, open circuit, thermal, ultrasonic, and RF protection Stable into reactive or mismatched loads |
Load Protection
|
On/off muting, AC coupling (850, 1450), triac crowbar (2450, on each channel) |
Dimensions |
19" (48.3 cm) rack mounting, 3.5" (8.9 cm) tall (2 rack spaces), 15.9" (40 cm) deep (rack mounting to rear support ears) |
Power Requirements |
100, 120, 230 VAC, 50-60 Hz |